This is a 3D printed probe to measure exactly 110mm from the bottom of the LP2 to the engraving surface. It is flexible by design so that it will not damage itself or your object when the engraver moves too close to the object.
Part
- 3D printed 110m probe (stl file)
- no support needed
- 15%+ infill, 0.2mm- layer height
- After printing, carefully separate the
/design with a shape knife so that the end of the probe can retract when pressed.
Usage
Push the end stopper to the bottom of the LP2, and lower the engraver till the tip of the probe touches the engraving surface without retraction.
The probe snaps onto the handle for easy storage.
Was this helpful?
6 / 0